Elite CSW200UL User Manual download pdf (Page 30)

TROUBLESHOOTING TA B L E

OVERLOAD LED ON

And

POWER LED OFF

1.Short circuit at terminals 8 and 10

2.Short circuit at any of the loop detectors in

the board

3.Short circuit in the control board

1.Remove the short circuit condition at the

terminals

2.Remove the defective loop detector

3.Sent the board to repair

OVERLOAD LED ON

And

POWER LED ON

1. Excessive current draw at terminal 10

2. Over-voltage at the 120 VAC line input

1. Reduce the accessories load from terminal 10

2. Verify your electrical power

SYSTEM ON LED FLASHING

1. One limit switch is faulty

2. Motor thermal fuse has pop-out

1. Test the limit switches and wire connections,

fix the fault

2.Reset the motor

REVERSE SENSOR LED ON

1.Gate has encounter and obstruction during

traveling

2.Reverse sensor is extra sensitive

1.Remove the obstruction

2. Turn counter-clock-wise the reverse sensor

pot a bit more and try again

ALARM SENSOR LED ON

1.Gate encountered and obstruction during

traveling

2.Alarm sensor is extra sensitive

1.Remove the obstruction

2. Turn counter-clock-wise the alarm sensor pot

a bit more and try again

ALARM SENSOR LED ON

1.Gate encountered and obstruction during

traveling

2.Alarm sensor is extra sensitive

1.Remove the obstruction

2. Turn counter-clock-wise the alarm sensor pot

a bit more and try again

COMMAND PROCESSED ON

1. There is a command hold active 1.This is a normal response of the gate

operator. It does not represent necessarily

that there is a problem.

TIMER LED BLINKING And

COMMAND PROCESSED

BLINKING

1. There is a command holding the gate open

1.This is a normal response of the gate operator.

It does not represent necessarily that there is a

problem. Check inputs for command.

TIMER LED BLINKING And

COMMAND PROCESSED

BLINKING

And

REVERSE SENSOR LED ON

1.Gate has reopened because it encountered an

obstruction while closing.

1.Any re-new command will resume normal

operation. Check for obstructions.

2. You can stop the alarm by using the stop

button.

AUDIO ALARM ON

1.Gate has encountered two consecutive

obstructions while trying to close or open

1.Any re-new command will resume normal

operation but not a radio command. Check

for obstructions.

ANY "LOOP LED" ON And

NO VEHICLE ON THE

SENSING AREA

1.The loop detector needs to be reset.

2.The wire loop has been disrupted

3.The loop detector needs to work in a

different frequency

4.The loop detector is too sensitive

1.Reset the loop detector (If you use Elite

Plug-in Loop detectors, change the setting

for sensitivity and come back to your original

setting).

2. Verify and correct connections

3.Set a different working frequency

4.Decrease the sensitivity of the loop detector

C O N D I T I O N

P OSSI BLE C A U SES S O L U T I O N

1 2 ... 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments